The Crankshaft Position Sensor also known as the crank position sensor is an electronic device used in an engine to record the rate at which the crankshaft is spinning. This information is used by the Electronic Control Module( ECM ) to control ignition and fuel injection. MIL ON WITH P0340 P0345 (CMP SENSOR) ANDOR ENGINE IS HARD TO START WHEN WARM APPLIED VEHICLES: 2003 2005 Altima A MIL ON with DTC P0340 (CMP Sensor Bank 1) andor P0345 (CMP Sensor Bank 2), Reference the current Nissan Warranty Flat Rate Manual Explore the Altima from Nissan.
Accelerate your pulse by discovering a new sedan that looks cool and is fun to drive. Aug 31, 2012 2003 Nissan Altima 2. 5S will not start Started with 70k miles when i got it and now its at 118k. The vehicle was working fine until it started stalling and was giving me the P0335 code which is the Crankshaft Position Sensor.
Nov 06, 2010 My check engine light comes on and when i get it to autozone to get it scanned, it gives me a P0340 (camshaft position sensor bank1 (passenger side)). So if I go get a new sensor, will it fix my problem w the stubbling on acceleration. Nissan Altima Service Manual Engine control system QR25DE for california Component diagnosis P0340 CMP sensor (phase) Description The camshaft position sensor (PHASE) senses the retraction of camshaft (INT) to identify a particular cylinder.
Nov 01, 2015 i went to start my car using the auto start and it stalled after what i thought was a Maf sensor i got the car checked and it threw code P0340 Camshaft Bank 1 Position Sensor Malfunction. below is my guide to the repair Feb 08, 2007 Something to do with the Exhuast gas recirculation (p0400) and cam position sensor A (p0340). What is causing me to lose speed and cause my car to choke at 3000 rpm I have the P0400 code, EGR and EGR temp sensor.
Jan 30, 2012 Re: P0340 Camshaft position sensor bank 1 DIY Post by cruzad3r Sat Dec 24, 2011 6: 22 pm Problem is fixed. i did not buy OEM nissan part because it's Xmas and i need the car. so i opt for Autozone Duralast Made in USA with 2 years warranty.
this cost about 60 bucks. you want to make sure you get P0340 nissan altima 98 manual straight sensor, not the angle one. Sep 10, 2013 So you have a no start with your 97 01 Nissan Altima and a check engine light with a p0340 code well the cam position sensor has gone bad and its built into the distributor.
Dec 21, 2014 This was performed on a 1997 Nissan Maxima. Please check with your vehicle's repair manual for testing parameters. Code P0340 could be generated by the following reasons: I have a 2004 nissan altima 2.
The Camshaft Position Sensor is an electronic device used in an engine to record the rate at which the camshaft is spinning. This information is used by the Engine Control Module() to control ignition and fuel injection. The camshaft position sensor senses the retraction of camshaft (intake) to