Jun 14, 2012 2005 Silverado OBD code P0332 Knock sensor If the knock sensor is bad will it cause the timing to be off and make the engine ping or is it something causing the timing to be of thus the ping and the knock code. P0332 code is your knock sensor and this code only shows up when there is a low output voltage from the sensor. It may be a couple of things perhaps the sensor is faulty, bad wire connection or a problem with the pcm but has nothing to do with the octane of your feul.
789. 00(OUCH! ! ) later I'm back on the road. Aug 10, 2013 Hello all, Recently (couple weeks ago) I replaced both knock sensors when my MIL came on and threw code P0332 (knock sensor bank 2 low voltage input IIRC). Vehicle Damage Warnings Also, in this manual you will nd these notices: Notice: These mean there is something that could damage your vehicle.
A notice tells about something that can damage the Jun 08, 2009 P0332 Knock Sensor 2 Circuit Low Bank 2. 03' Suburban. Discussion in 'Performance& Fuel' started by SoundZman, May 27, 2009.
SoundZman Rockstar 100 Posts. So my wife was pull on to the freeway this afternoon when the CEL came on. I took it down to AZ, borrowed their scanner came up with the above. P0332 Knock Sensor 2 Circuit Low (Bank 2) Technical Description. Knock Sensor 2 Circuit Low Input (Bank 2) What does that mean? This diagnostic trouble code (DTC) is a generic powertrain code, which means that it applies to OBDII equipped vehicles. Jun 29, 2006 01: 41 PM Post# I got a code P0332 and found out that the sensor is under the intake manifold.
is the replacement something I can do myself or better not, and if yes, do I need any kind of new gaskets to buy before I do the job? replaced both knock censors and the wire harness for them still getting the p0332 code for knock sensor 2 bank 2 any ideas where to go from here?